Revcon Forums
http://policeinterceptor.com/revconforums/

1984 brake shoe and pad information requested
http://policeinterceptor.com/revconforums/viewtopic.php?f=2&t=154
Page 1 of 1

Author:  Kdredman [ Sun Apr 15, 2018 5:38 pm ]
Post subject:  1984 brake shoe and pad information requested

Does anyone know the part number or brake pad and shoe type on a 1984 king 33?

Author:  trueblue2k2 [ Sat Apr 21, 2018 3:28 am ]
Post subject:  Re: 1984 brake shoe and pad information requested

I too have an '84 King, and I just posted my intro to new members forum.

I replaced pads and one disk on mine last year after replacing my hub ass'y. There is an article somewhere about the parts. What I can remember is that they are Ford Truck parts, and the disk requires a slight lathe reduction in diameter to clear the Revcon calipers. The correct disk has 8 stud holes, and may be the only such one Ford makes (get matching high cof ceramic pads). I can't recall part numbers, but they are likely in the parts list hereabouts. There was some detail my mechanic said about stud hole size too small and needed drilling?? Check out those details.
Rear shoes are to fit the Dexter axles, and can be found in that parts list as well. I intend to install the $500 rear disk brake mod myself since better braking is needed. It is explained in a forum article.
The Dexter axles use an oil lube design and often the plastic caps warp from heat and oil is gone. Solution is to just pack them with grease instead. Regards -Bill

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/