Revcon Forums
https://policeinterceptor.com/revconforums/

Fuel Tank Sending Unit
https://policeinterceptor.com/revconforums/viewtopic.php?f=10&t=203
Page 1 of 1

Author:  JBC [ Tue Apr 06, 2021 1:12 pm ]
Post subject:  Fuel Tank Sending Unit

Hello,
I have a 1972 Revcon 250 that needs a Fuel Tank Sending Unit replaced, does anyone know what sending unit they may have used on this coach. Any information would be greatly appreciated.
Thanks Joe

Author:  Daveinet [ Wed Apr 07, 2021 12:58 pm ]
Post subject:  Re: Fuel Tank Sending Unit

Is the resistor still good? IF so, you could measure the resistance. This would let you know which type it is. Then order one from Summit racing.

Author:  JBC [ Sat Apr 10, 2021 12:06 am ]
Post subject:  Re: Fuel Tank Sending Unit

Thanks for information, no couldn’t measure resistance in too bad of shape but did get a new universal one that seems to read right.

Author:  Daveinet [ Thu Apr 15, 2021 12:11 am ]
Post subject:  Re: Fuel Tank Sending Unit

Yes, there are two basic standards and I could not remember which one was used. That was one of the reasons I went to an electronic dash on my coach. I replaced the fuel tank and the new sending units were not compatible. I went to an all digital dash.

Author:  JBC [ Thu Apr 15, 2021 11:57 am ]
Post subject:  Re: Fuel Tank Sending Unit

If you don’t mind telling me where did you get a new fuel tank, or did a metal shop make it for you ?

Author:  Daveinet [ Sat Apr 17, 2021 6:15 pm ]
Post subject:  Re: Fuel Tank Sending Unit

They were actually surplus plastic fuel tanks for boats. Two 40 gallon. Brand new. They were 8 inches tall, and 2 feet wide and 4 feet long. It was a boat salvage and surplus store. If I remember correctly, they were 200 buck each. I searched on and off for about 2 years before I stumbled on these. I had to drill one of the access place to install an extra pickup for the generator, but that was the only modification to the tank. I built a frame to support them and hold them to the bottom of the coach. For the sending units, I used a 4 pin trailer connector just in case I needed to pull them again.

Author:  JBC [ Sat Apr 17, 2021 8:01 pm ]
Post subject:  Re: Fuel Tank Sending Unit

Thank you for the information, plastic tanks would be a better choice anyway. Very good idea.

Author:  Daveinet [ Fri Apr 23, 2021 5:53 pm ]
Post subject:  Re: Fuel Tank Sending Unit

Just make sure if you are buying a plastic tank that it is made for fuel. The plastic tanks I bought were coated inside. Just curious how tall of a tank will fit?
http://www.moellermarine.com/wp-content ... -10-19.pdf
Here is a list from Moeller Marine. I'm pretty sure that is who made my tanks. I see a 36 gallon tank that is only 8 inches high, or a 48 gallon tank that is 9 inches high. Do as I did, mount two tanks side by side, longitudinally. They will never leak, but they are expensive. I was fortunate to find mine surplus.

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/