Revcon Forums https://policeinterceptor.com/revconforums/ |
|
84 slant nose tie rod ends https://policeinterceptor.com/revconforums/viewtopic.php?f=14&t=202 |
Page 1 of 1 |
Author: | GeorgiaRevcon [ Tue Apr 06, 2021 12:15 am ] |
Post subject: | 84 slant nose tie rod ends |
I have tried everywhere to find tie rod ends for my 84 Revcon 454 Chevy engine. Can anyone please help on this? I believe they are Moog. got the rotors and calipers they were for a Ford F-350. If anyone has any information on the tire rod ends it will be greatly appreciated all the other work is complete. |
Author: | elc32955 [ Sun Apr 18, 2021 9:11 am ] |
Post subject: | Re: 84 slant nose tie rod ends |
I'll just throw my .02 in here, Rick Herbst had told me one time on the tie rod ends to check those for the Hummer H1 and perhaps the military HWMV. The tie rod ends were one of the most closely guarded secrets that Marty Moore sourced & sold, he always reboxed whatever he got so as not to reveal the sourcing information and to keep the customers coming. RIP Marty, but in the end it was a disservice to the community as we do not know the exact interchange. Or at least I don't. Dave might be able to pass along some info there as well... Thanks Eric |
Author: | Daveinet [ Tue Apr 20, 2021 12:08 pm ] |
Post subject: | Re: 84 slant nose tie rod ends |
Dave doesn't know either. Several years ago I was in CA on a business trip, so I stopped by his shop to pay him a visit. We chatted for a while. In the conversation I mentioned that I was the person who discovered the lower ball joint replacement. He reaction was very neutral, which I read to be he didn't like the idea that someone had come up with a replacement. The irony is that he only had 4 left and had stated that he was not able to purchase any more from his source. My gut feeling is that he was sourcing this from the same source as the OEM, rather than buying a known part for an XYZ vehicle. So those sources may be completely dried up anyway. But in the end, there has to be a truck part somewhere that matches up. No one is going to pay the cost to have one custom made. That does not make sense. I would be inclined to also look at some agricultural sources as well. Here is just one source that provides dimensions: https://qualityfarmsupply.com/collections/tie-rod-ends Not sure if anything fits, but it would be a place to start. There are several options that are 1 inch diameter threads, so it is very likely there will be something within those 13 pages that will match up. Make sure to pay attention to LH or RH threads. Revcon used both, depending on location. |
Author: | GeorgiaRevcon [ Fri Apr 23, 2021 1:24 am ] |
Post subject: | Re: 84 slant nose tie rod ends |
Thanks Dave |
Page 1 of 1 | All times are UTC |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |